Разширяване на следата (фланци) H&R TRAK+® Wheel Spacers черен B0655665 за Mercedes AMG GT (X290) 4.0 63 S E Performance 4-matic+ (290.679) - 843 коня бензин/електро

За автомобил:

Mercedes AMG GT (X290) 4.0 63 S E Performance 4-matic+ (290.679)

Двигател:

843 коня - 620 kW - бензин/електро

Парт номер:

B0655665

Производител:

долен преден мост с граница на запресоване [mm]:

7 mm

долен заден мост с граница на запресоване [mm]:

2 mm

мярка на резбата:

M14x1,5

джанта:

не е за стоманени джанти

разширение на следата [mm]/ос:

6 mm

дебелина [mm]:

3 mm

брой на дупките:

5

Кръг на дупките Ø [mm]:

112 mm

центриращ диаметър [mm]:

66,5 mm

цвят:

черен

вид регистрация:

с експертиза от TÜV®

да се спазван инструкциите за монтаж:

обща информация:

Please note additional information and vehicle-specific technical notes!

технически данни:

DR = The wheel spacer should be fitted between the wheel and the axial hub using longer bolts not supplied - please order separately. When ordering the longer bolts please state which cone type you require (i.e. taper, round, loose round or flat) and the required extra length. All screws for the DR systems have to be orderded separately.

технически данни:

All DR-Systems require longer wheel-bolts. These have to be ordered separately. When ordering wheel-bolts please follow these guidelines: If possible name the type of the wheel when ordering. New bolts must be longer than the original ones by half of the total Track-widening. For example: With a 30 mm DR-kit you will require bolts that are 15 mm longer than the original bolts. The bold-head must be identical to the existing bolt: Taper 60° Round-head for M12/d24 mm, for M14/d28 mm Round-head for M12/d26 mm (e.g. OE VAG-wheels) Flat-head with disc for CITROEN/PEUGEOT-vehicles M12x1,25 Flat-head for PORSCHE-original-wheels M14x1,5 Safety Guidelines (No. of turns for wheel screws) M12x1,5 = 6,5 turns = approx. 10 mm of load bearing shaft length M12x1,25 = 8,0 turns = approx. 10 mm of load bearing shaft length M12x1,75 = 6,5 turns = approx. 12 mm of load bearing shaft length M14x1,5 = 7,5 turns = approx. 12 mm of load bearing shaft length 1/2"UNF = 8,0 turns = approx. 11 mm of load bearing shaft length Please ensure that the wheel screws do not damage any part of the brake system (ABS sensors etc.) Turn the wheel first by hand and check clearance on the inside (max. tolerance for some vehicles is only 2 mm (RA Mercedes).

технически данни:

These spacers without a double-sided centering are only useable for cars with a sufficient length of the centering to be able to center the wheels enough despite the spacer.

обща информация:

Not usable with steel-rims!